Advantages of BiMast noise insulation materials

In our previous publications, you were able to get acquainted with the general data of BiMast soundproofing, as well as with soundproofing materials Vibroton . In this article, we invite you to find out the positive qualities of Bimast materials, as well as their technical characteristics.

Advantages of Bimast materials

• Increases structural rigidity (G _{steel 1.0 mm+ BiMast} = G _{steel 1.2 mm.} ). In this case, a significant decrease in the sensitivity of the plate to vibration is observed; the number of resonances decreases.
• When using Bimast Bomb, the coefficient of mechanical loss of materials reaches 0.4.
• Bimast Bomb and Bimast Super effectively absorb vibrations on metal with a thickness of 2 to 4 mm.
• Bimast materials, due to the high CMF and the effect of increasing stiffness, allow processing a smaller area (about 40-55%) of the surface, while increasing vibration absorption.
• Does not increase the mass of the car when processing a smaller surface; the effect of vibration absorption at the same time remains at a high level.
• It brings the greatest benefit in the most vibration-loaded areas: wheel arches, engine compartment, car floor, trunk, roof. KMP = 0.4.
• Thanks to the adhesive mastic base, it serves as an anti-corrosion coating.
• High elasticity allows in most cases to work without a heat gun. The exception is machined corners with a rounding of less than 30 mm.
• The material is easily cut with both a knife and scissors. At the same time, the tool does not get stuck in a thick mastic layer, as when working with Vibroplast.
• The absence of foil reduces the risk of injury during installation and cutting. When mounting foil material, hand cuts often occur.
• Counterfeit protection. The original packaging, the application of the StP and BiMast logos on the front layer increases the degree of protection against counterfeiting.

Characteristics of Bimast materials

Requirements for the physical and mechanical properties of products: